manual ribbon cable standard press and tool kit for sl? n adjustable for 2 to 25 circuits, which provides for production fexibility n tooling termination kit easily mounted in the molex manual standard press and can be quickly removed which will increase productivity and reduce change over time n full-cycle ratch assures quality terminations n adjustable cable guides and stop for repeatable cable/ connector alignment for various cable size requirements which lower overall cost through reduced tooling inventory n no air or electricity required which reduce overhead cost n bench mounted operation that requires minimal space n molex manual standard press accepts many molex tooling kits for various molex products that provide fexibility in the changing marketplace and reduces overall cost mechanical dimensions: with press and tool kit height533.00mm (21.000) width152.00mm (6.000) depth408.00mm (16.100) weight27.2kg (60 lb) tool kit only: height51.00mm (2.000) width127.00mm (5.000) depth178.00mm (7.000) weight2.5kg (5.5 lb) features and benefts the molex sl ribbon cable terminator kit is designed to be used in the molex manual standard press. this tool system terminates the sl idt (insulation displacement technology) 70400 and 70475 connectors onto pre-notched ribbon cable. this tool system provides an effective and fexible method of termination. the molex manual press has a full-cycle ratchet arm which assures the quality of the termination. this tool system will also accommodate 2 to 25 circuits which provides fexibility. it also features adjustable cable guides and stop for repeatable cable and connector alignment. operation: the operator loads a connector into the nest of the terminator kit (which is installed in the molex manual standard press), sets the cable stop and positions the cable over the terminals. the operator cycles the ratch arm on the press to complete the termination and then removes the harness. the terminals must be pushed into the housing by hand and then the carrier strip must be broken off by hand. the operation is complete. the product rate of this tool system is approximately 150 assemblies per hour depending on operator skill and application. features and specifications americas headquarters lisle, illinois 60532 u.s.a. 1-800-78molex amerinfo@molex.com far east north headquarters yamato, kanagawa, japan 81-462-65-2324 feninfo@molex.com far east south headquarters jurong, singapore 65-6-268-6868 fesinfo@molex.com european headquarters munich, germany 49-89-413092-0 eurinfo@molex.com corporate headquarters 2222 wellington ct. lisle, il 60532 u.s.a. 630-969-4550 fax:630-969-1352 visit our website at www.molex.com order no. dhl-0011 printed in usa/100/ji/ji/2006.05 ?2006, molex ordering information order no. description 62201-6600 tool kit only 11-31-6356 molex manual standard press manual st andard press cable stop cable guides lower tooling upper tooling ra tchet arm 62201-6600
|
